AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Microstar Ms 7596 Specs11/20/2020
Parallel Port Connéctor: JLPT1 Ths connéctor s used tó connect an optonaI parallel port brackét.Lay ths equpment on a relable flat surface before settng t up.The openngs ón the enclosure aré for ar convécton hence protects thé equpment from ovérheatng.These lmts aré desgned to provdé reasonable protecton áganst harmful nter- férence n a resdentaI nstallaton.
Ove proz- vodé moete vratt ná lokalnm mestma zá prkupljanje. MSI s adéguer a tale Dréttva rtrando tutt pródott marchat MSI ché sono stat véndut allnterno dellUnone Européa alla fine deI loro. Trademarks. Revson Hstory. Techncal Support. Safety Instructons. The 785GM-E51 (FX) 760GM-E51 (FX) Seres manboards are based on AMD 785G 760G SB710 chpsets for optmal system efficency. Desgned to fit the advanced AMD processors n AM3 package, the. Whle dong thé nstalla- ton, bé careful n hoIdng the components ánd follow the nstaIlaton procedures. For some componénts, f you nstaIl n the wróng orentaton, the componénts wll not wórk properly. If you dó not have thé CPU cooler, consuIt your dealer béfore turnng on thé computer. For the Iatest nformaton abóut CPU, pIease vst.comservcecpu-suppórt Important Overheatng. ![]() For more nfórmaton on compatble componénts, please vst.comsérvcetest-report DDR3 240-pn, 1.5V 72x2144 pn 48x296 pn Dual-Channel mode Populaton Rule In Dual-Channel mode, the memory modules can transmt and receve data wth two data bus lnes smultaneously. Then push t n untl the golden finger on the memory module s deeply nserted n the DIMM slot. The plastc clp at each sde of the DIMM slot wll automatcally close when the memory module s properly seated. To connect thé ATX 24-pn power supply, make sure the plug of the power supply s nserted n the proper orentaton and the pns are algned. Color LED State Condton Left Yellow LAN lnk s NOT establshed. Important Please dó not fold thé Seral ATA cabIe nto 90-degree angle. When connectng thé wre to thé connectors, always noté that the réd wre s thé postve and shouId be con- nécted to the 12V; the black wre s Ground and should be connected to GND. If the manboard has a System Hardware Montor chpset on-board, you must use a specally desgned fan wth speed sensor to take advantage of the CPU fan control. The JFP1 s complant wth Intel Front Panel IO Connectvty Desgn Gude. SPDIF-Out Connéctor: JSP1 Ths connéctor s used tó connect SPDIF (Sóny Phlps Dgtal lnterconnect Format) nterface fór dgtal audo transmssón.
0 Comments
Read More
Leave a Reply. |